**The**

**fast non-leakage factor**, P_{f}, is defined as the ratio of the number of fast neutrons that do not leak from the reactor core during the slowing down process to the number of fast neutrons produced by fissions at all energies.**In an infinite multiplication system, the leakage of the system is logically neglected. But all multiplying systems, all realistic reactor cores are finite multiplying systems, and this process may not be neglected. During the slowing down process, some of the neutrons leak out of the boundaries of the reactor core before they become thermalized. This process and its impact on the effective multiplying factor is characterized by the fast non-leakage factor, P_{f}, which is defined as the ratio of the number of fast neutrons that do not leak from the reactor core during the slowing down process to the number of fast neutrons produced by fissions at all energies.**

**1030**

**↓**

**P _{f} ~ 0.95**

**↓**

**979**

Note that, there is the consistency between the numerator in the definition of

**ε**and the denominator in the definition of P

_{f}.

**0.92 – 0.98**and this value is minimally affected (in comparison with the other factors) by operational changes except changes in the moderator temperature. It can be derived from the Fermi age theory, the probability that a neutron will remain in the core and become a thermal neutron without being lost by fast leakage, is also

**represented by following equation:**

where **τ** is **fermi age of a neutron**, **B** is the **geometrical buckling** (in case of critical state B_{g} = B_{m}), which depends only on the shape and size of the core. The value of **B** **for small cores is higher** than the value for large cores. So that, it is obvious, the fast neutrons leakage is higher for small cores and depends on the macroscopic slowing down the power of neutron moderator (leakage is higher for poor moderators).

## Total Non-leakage Probability

**The fast non-leakage probability** (P_{f}) and **the thermal non-leakage probability** (P_{t}) may be combined into one term that gives the fraction of **all neutrons** that do not leak out of the reactor core. This term is called** the total non-leakage probability** and is given the symbol P_{NL}, and may be expressed by the following equation:

We can rewrite this equation without a substantial loss of accuracy for large reactors simply by replacing the diffusion length L_{d} and τ with the migration length M in the one group equation. The term **B ^{4}** is very small for large reactors, and therefore it can be neglected. We may then write.

where M is the **migration area (m ^{2})**, the migration length is defined as the square root of the migration area.

## Main operational changes that affect this factor:

Since both (**P _{f} and P_{t}**) are affected by a change in

**moderator temperature**in a heterogeneous water-moderated reactor and the directions of the feedbacks are the same, the resulting

**total non-leakage probability**is also sensitive to the change in the moderator temperature. As a result, an

**increase in the moderator temperature**causes that the probability of

**leakage to increase**. This effect is one of two main effects causing the

**moderator temperature coefficient (MTC)**of most PWRs to be negative.

**The fast neutron leakage** is also dependent on the core temperature (or moderator temperature). **The moderator temperature** influences macroscopic cross-sections for elastic scattering reaction (**Σ _{s}=σ_{s}.N_{H}_{2}O**) due to the

**thermal expansion**of water. As the temperature of the core increases, the

**fast neutron leakage increases**. This physical process is a part of the

**moderator temperature coefficient**(MTC) and it is responsible for an increase in neutron flux measured by neutron detectors, which are situated around the reactor vessel.